RTK reference station is replaced, how to pair new with Luba.
Please follow the steps below to pair the new RTK reference station on the App.
1. Find the new RTK paring code from the new RTK reference station sticker.
2. Open the Mammotion App and connect Luba.
3. Go to Settings > Device settings > RTK paring code.
4. Tap on Change, input the new RTK paring code, and then tap Confirm.
Then the new RTK reference station is paired and all should work now.
Related Articles
How to pair new RTK reference station with LUBA.
Please refer to the following steps to pair the new RTK reference station. 1. Find the new RTK paring code from the new RTK reference station sticker. 2. Open the Mammotion App and connect Luba. 3. Go to Settings > Device settings > RTK paring code. ...What is the best installation place for RTK Reference Station?
The distance between RTK Reference Station to the walls, roof, or trees should be ideally distanced by 45° from RTK Base to the height of walls, roof, or trees as shown below. Or install the RTK Reference station on the wall or roof with an open sky ...About the NEW positioning information and how to troubleshoot the related issues.
NEW positioning information under POS on the App. Explanation of the NEW positioning information. Positioning status： Fix: Fine positioning status, accuracy less than 10cm, up to 2cm with the good open-sky area; (can auto mowing) Float: Bad ...About the NEW positioning information and how to troubleshoot the related issues.
NEW positioning information under POS on the App. Explanation of the NEW positioning information. Positioning status： Fix: Fine positioning status, accuracy less than 10cm, up to 2cm with the good open-sky area; (can auto mowing) Float: Bad ...What will happen if I move the RTK reference station to another position?
You'll need to delete the current map and recreate it if you move the RTk reference station to anotherposition. The whole map is created based on the realposition of the RTK reference station. The logisticposition of the map will be offset after ...