Task Settings

Task Settings

  1. Frequency
You can set the working frequency here.
  1. Now — The robot will commence work promptly upon configuration.
  2. Weekly — The robot will repeat the task every week based on your preferences.
  1. Cutting path angle (°)
    1. Optimal：Take the most efficient path recommended by the algorithm as the 0-degree direction.
  1. Customize：The adjustment angle range is 0 to 180°.
  1. Perimeter working
When enabled, the robot will work along the perimeter. When disabled, the robot will avoid working at tthe perimeter.
  1. Obstacle avoidance
    1. Off：The robot will attempt to reach every spot of the selected areas. When encountering an obstacle, it will gently bump into it and then navigate around, ensuring a cleaner trim along walls and obstacles. 
  1. Standard：The robot will proactively avoid obstacles to prevent collisions, which reduces damage and improves efficiency.
  2. Sensitive：The robot will proactively avoid obstacles and non-grassy areas, reducing the risk of falling or leaving the lawn. However, some dried-out
    patches may be missed and could also block the returning path.

    • Related Articles

    • How to Set Mowing Task

      Preparation If any unexpected problems arise, please press the STOP button and secure the robot. The STOP button holds top priority among all commands. If the lift sensor is activated, the robot will come to a halt. Please press the Grass button ...

    • Map your Lawn and Create Task Area

      Before Mapping-Preparation Before mapping, it is important to be aware of key considerations. Remove debris, piles of leaves, toys, wires, stones, and other obstacles from the lawn. Make sure no children or animals are on the lawn. Map Your Lawn 1. ...

    • How to Create Channel

      The channel is intended to connect various task areas or link the task area with the charging station. 1. Tap Create > Channel on the map page. 2. Control the robot into a task area. Tap to start mapping. 3. Manually control the robot from a task ...

    • Non-working Periods

      1. Open the Settings menu. 2. Select Non-working Periods. 3. In the Non-working Periods section, configure specific times to mark as non-working periods.

    • Turnaround Mode

      There are two turnaround modes: Zero Turn and Multi-point Turn. ● Zero Turn — When entering the next cutting path, the robot will make an in-place turn, which may cause some wear on the grass. ● The robot will perform three round-trip, progressive ...