Switch Positioning Mode

Switch Positioning Mode

RTK Link Mode refers to the method of connection between an RTK reference station and a robot. We will introduce two modes in this page: Antenna over Datalink and Antenna over Internet. 

Antenna over Internet

Antenna over Internet utilizes the internet for data communication between the RTK reference station and the robot. It significantly expands the range of RTK applications, enabling operation over large geographical areas.

Quote

IMPORTANT

● Antenna over Internet relies on a stable 4G network. It is crucial to ensure that the robot maintains a reliable 4G connection.

● Please ensure that both robot and RTK reference station are bound to the same account.

● For optimal operation, it is recommended to update both robot and RTK reference station firmware to the latest versions.

Enable Antenna over Internet

1. Verify the 4G icon on the Status bar to illuminate, indicating successful activation of the SIM card. Tap the Status bar to access the status information page.

2. Tap Positioning Mode.


3. Select Antenna over Internet and tap the RTK reference station to configure your network.

4. Wait for a green check mark to appear, then return to the status information page. Verify that the RTK positioning status displays 'Fix' and the RTK connection shows 'Connected'. Your setup is now complete.

Antenna over Datalink

Antenna over Datalink involves data communication between the RTK reference station and the robot using radio antennas.

Enable Antenna over Datalink
1. Tap the Status Bar to access the status.
 
2. Tap Positioning Mode.
3. Select Antenna over Datalink, and ensure the displayed datalink number matches the one on the RTK reference station's nameplate. If not, input the correct one. Tap OK to proceed. 
4. Return to the status information page and verify that the RTK link mode displays 'Antenna over Datalink', the RTK positioning status shows 'Fix', and the RTK connection status shows 'Connected'. Your setup is now complete.





    • Related Articles

    • Turnaround Mode

      There are two turnaround modes: Zero Turn and Multi-point Turn. ● Zero Turn — When entering the next cutting path, the robot will make an in-place turn, which may cause some wear on the grass. ● The robot will perform three round-trip, progressive ...

    • Map your Lawn and Create Task Area

      Before Mapping-Preparation Before mapping, it is important to be aware of key considerations. Remove debris, piles of leaves, toys, wires, stones, and other obstacles from the lawn. Make sure no children or animals are on the lawn. Map Your Lawn 1. ...

    • How to Set Mowing Task

      Preparation If any unexpected problems arise, please press the STOP button and secure the robot. The STOP button holds top priority among all commands. If the lift sensor is activated, the robot will come to a halt. Please press the Grass button ...